How do I add baseboards to Revit?

How do you add crown molding in Revit?

In a 3D or elevation view, click Architecture tab > Build panel > Wall drop-down > Wall: Sweep. On the Properties palette, click Edit Type, or click Modify | Place Sweep tab > Properties panel > Type Properties. In the Type Properties dialog, for Profile, select the desired Crown Molding profile type.

How do you create a sweep family in Revit?

Create a Sweep

  1. In the Family Editor, on the Create tab Forms panel, do one of the following. …
  2. Specify the sweep path: …
  3. On the Mode panel, click (Finish Edit Mode).
  4. Load or sketch a profile. …
  5. On the Properties palette, specify the sweep properties. …
  6. On the Mode panel, click (Finish Edit Mode).

How do I create a wall sweep in Revit?

Add a Wall Sweep

  1. Open a 3D or elevation view containing the wall to which you want to add the sweep.
  2. Click Architecture tab Build panel Wall drop-down (Wall: Sweep).
  3. In the Type Selector, select the desired type of wall sweep.

How do you add a floor in Revit?

Create a Floor

  1. Click Architecture tab Build panel Floor drop-down (Floor: Architectural). Where is it?
  2. Draw the floor boundaries, using one of the following methods: Pick walls: By default, Pick Walls is active. …
  3. On the Options Bar, for Offset, specify an offset for the floor edges. …
  4. Click Finish Edit Mode.
IT IS INTERESTING:  Best answer: Can SketchUp be used on Android?

How do I add a wall in Revit?

Place a Wall

  1. Open a floor plan view or a 3D view.
  2. Click Architecture tab Build panel Wall drop-down (Wall: Architectural).
  3. If you want to place a wall type other than the one displayed in the Type Selector, select a different type from the drop-down. …
  4. On the Options Bar, specify the following:

How do you add a wall in Revit?

Add exterior walls by drawing them using selected points.

Add Interior Walls

  1. Click Modify tab Modify panel (Split Element).
  2. Click on the wall at the location indicated by the short red line in the previous image.
  3. On the Modify panel, click (Trim/Extend to Corner).
  4. Trim the split wall to create a corridor as shown.